Streaming potential measurements on stainless steels surfaces: evidence of a gel-like layer at the steel/electrolyte interface

Electric charges at the surface of a passive stainless steel are generally considered as concentrated either in the passive film itself, or at the metal/passive film interface, or in the electrical double layer at the film solution interface. Rest potential time dependence after immersion of a passive surface in aqueous electrolytes suggests however that slow processes occur in the onset of the surface charge. Specific experiments, such as streaming potential measurements and electrochemical impedance spectroscopy in a thin electrolyte cell, were carried out for understanding better this phenomenon. An AISI 304 type austenitic stainless steel with polished or bright annealed surface finishes was immersed in NaCl aqueous solutions with various pH and chloride concentrations. The streaming potential time evolution shows two steps: a first rapid one (∼2 min) is attributed to the onset of the surface charge. The second step is much slower (approximately several hours) and possibly due to an interphase layer between the passive film and the solution. Following this idea, the whole kinetics is controlled by cation migration across the interphase when the pH is larger than the isoelectric pH (pH_iep), while chloride ions are incorporated in the interphase when pH < pH_iep. Impedance measurements allow determining both the kinetics of charge transport and the thin cell conductivity. When glass is used as reference material for the cell walls instead of stainless steel, the Nyquist plots show a high-frequency response. For stainless steel cell walls, a low-frequency response is observed, attributed to a slow charge reorganisation inside the interphase layer. The charge distribution at metal/electrolyte interface is discussed in terms of a gel-like layer which possibly takes place at the passive film/electrolyte interface.