Higher order structures and mechanical properties of bacterial homo poly(3-hydroxybutyrate) fibers prepared by cold-drawing and annealing processes

Pure bacterial homo poly(3-hydroxybutyrate) (PHB) fibers were prepared by melt spinning, followed by cold-drawing in an amorphous state at a temperature just above its glass transition temperature. Cold drawn fibers obtained were further drawn at higher temperatures, followed by annealing at various temperatures under tension. Relations among the processing conditions, higher order structures and mechanical properties were investigated using wide- and small-angle X-ray diffractions (WAXD and SAXD, respectively), birefringence, differential scanning calorimetry (DSC), and tensile measurements. PHB has two different crystalline forms, 2₁ helix conformation (α-form) and planar zigzag conformation (β-form). A single broad reflection of β-form was detected even in a PHB fiber drawn once at a temperature just above its T_g immediately after quenching and it tended to be stronger after 2nd drawing at higher temperatures. Annealing under low temperature and high tension facilitates the occurrence of β-form. It is suggested that the β-form crystal is formed not only from the tie chains between α-form lamella, but also from completely free amorphous chains. Changes in the amount of two types of crystals were analyzed using the WAXD integrated intensity. Birefringence of these fibers shows negative and positive values, depending on process conditions. Changes in higher order structure on the mechanical properties are also discussed.