| 14Cr1MoR钢控轧和直接淬火工艺研究 |
| |
| 引用本文： | 马有辉,蔡庆伍,陈银莉,江卫华.14Cr1MoR钢控轧和直接淬火工艺研究[J].上海金属,2006,28(4):48-51. |
| |
| 作者姓名： | 马有辉 蔡庆伍 陈银莉 江卫华 |
| |
| 作者单位： | 1. 北京科技大学高效轧制国家工程研究中心,北京,100083
2. 北京科技大学材料学院 |
| |
| 摘 要： | 研究控制轧制和直接淬火相结合生产14Cr1MoR压力容器钢的工艺.结果表明奥氏体再结晶区变形时,单道次变形量越大则再结晶进行得越充分,再结晶后的晶粒就越细.奥氏体未再结晶区总变形量增大则奥氏体晶粒内形变区域增多,从而使马氏体形核点增多,淬火后得到细板条马氏体组织.该钢种控轧后有足够高的温度进行直接淬火,经高温回火得到细小回火索氏体,机械性能优良.
|
| 关 键 词： | 14Cr1MoR钢 控制轧制 直接淬火 显微组织 机械性能 |
| 收稿时间： | 2006-01-13 |
| 修稿时间： | 2006年1月13日 |
CONTROLLED ROLLING AND DIRECT QUENCHING FOR 14Cr1MoR STEEL PLATE |
| |
| Ma Youhui,Cai Qingwu,Chen Yinli,Jiang Weihua.CONTROLLED ROLLING AND DIRECT QUENCHING FOR 14Cr1MoR STEEL PLATE[J].Shanghai Metals,2006,28(4):48-51. |
| |
| Authors: | Ma Youhui Cai Qingwu Chen Yinli Jiang Weihua |
| |
| Affiliation: | 1. National Engineering Research Center for Advanced Rolling Technology, University of Science and Technology Beijing; 2. School of Materials Science and Engineering, University of Science and Technology Beijing |
| |
| Abstract: | The combination techniques of controlled rolling and direct quenching for 14Cr1MoR steel of pressure vessels were studied. When the austenite was deformed in the recrystallization region, sufficient deformation per pass brought about fully recrystallization, and refined the grain. Higher deformation amount in non-recrystallization austenite region increased the deformation regions in the austenite grains, and increased the nucleating points for martensite, which led to fine plate martensite structure after quenching. The steel with enough high temperature after controlled rolling could be quenched directly, and a fine tempered sorbite with favorable mechanical properties after high tempreture tempering could be obtained. |
| |
| Keywords: | 14Cr1MoR Steel Controlled Rolling Direct Quenching Microstructure Mechanical Property |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
