Fabrication of ceramic sealing coatings for shell bionic structures and their failure mechanism during thermal cycling

The porous ceramic coating as a "brick" layer sprayed by air plasma spraying(APS) and MK resin as a "mud" layer prepared by a high viscosity spray gun were characterized and tested. Three specifications of the "brick-mud" layered ceramic sealing coating were fabricated through the cyclic and orderly deposition of the "brick" layer and "mud" layer, and the thermal cycling performance and failure mechanism of the three new coatings were studied. The results showed that the agglomerated Y₂O₃ partially stabilized ZrO₂ (YSZ) particles had porous spherical structures and good sprayability, and the content of the YSZ phase in the prepared "brick" layer was 54.2%. The "mud" layer had good phase stability and was amorphous SiO₂ at and below 1100 °C. The fracture toughness of the pure YSZ coating was 2.295 ± 0.135 MPa?m^0.5, and which of the “mud” layer was reduced by 72.3%. The thermal cycling life of the conventional coating was only 67.3 times, which of A1, A2 and A3 coatings with 2, 3 and 6 "mud" layers were increased by 32.4%, 124.8% and 88.3%, respectively. In the thermal cycling process, the "weak" layer in the "brick-mud" layered coating led to the redistribution of internal stress and reduced the stress concentration in the top coating (TC)/TGO interface. Moreover, the initiation of microcracks in the "weak" layer, along with the "crack branching" effect and the "crack deflection" effect during the crack propagation process, could consume partial internal stress. Thus, the crack growth rates in the TC coating/TGO interface of the A1, A2 and A3coatings were lower than that of the conventional coating due to the above stress release mechanisms. In addition, the thermal cycling lives of the three new coatings with 2, 3 and 6 "mud" layers were improved to different degrees because of different stress effects.