Cu-10Sn-4Ni-3Pb Alloy Prepared by Crystallization Under Pressure: An Experimental Study |
| |
作者姓名: | Kexing SONG Yanjun ZHOU Peifeng ZHAO Yanmin ZHANG Ning BAI |
| |
作者单位: | [1]School of Materials Science and Engineering, Henan University of Science and Technology, Luoyang 471003, China [2]Henan Key Laboratory of Advanced Non-ferrous Metals, Luoyang 471003, China [3]Xi'an Jiaotong University, Xi'an 710049, China |
| |
基金项目: | Acknowledgements This work was financially supported by the National Natural Science Foundation of China (Nos. 51075122 and U1034002). |
| |
摘 要: | The wear-resistant tin bronze (Cu-10Sn-4Ni-3Pb) with tin content above 8 wt.% prepared by traditional melting and casting process usually defects such as low density, poor properties and segregations. The crystallization under pressure processing of Cu-10Sn-4Ni-3Pb alloy was investigated. The microstructures were observed and analyzed and compared with that by traditional melting and casting process. The results show that the dendrite has obviously disappeared and the dendritic segregation alleviated by using the crystallization under 680 MPa pressure process, in comparison with the remarkably dendrite microstructure and severe as-cast defects of alloy prepared by traditional melting and casting technology. Based on the experimental study, the properties and microstructures of Cu-10Sn-4Ni-3Pb tin bronze prepared by crystallization under pressure have been improved significantly.
|
关 键 词: | Cu-10Sn-4Ni-3Pb bronze Crystallization under pressure Microstructure Segregation |
本文献已被 CNKI 维普 等数据库收录! |