| 误差和载荷耦合作用下蜗杆传动的啮合控制 |
| |
| 引用本文： | 石万凯,秦大同,徐戊娇.误差和载荷耦合作用下蜗杆传动的啮合控制[J].中国机械工程,2003,14(23):1999-2001. |
| |
| 作者姓名： | 石万凯 秦大同 徐戊娇 |
| |
| 作者单位： | 1. 重庆大学机械传动国家重点实验室,重庆市,400044
2. 重庆大学机械工程学院,重庆市,400044 |
| |
| 基金项目： | 高等学校博士学科点专项科研基金资助项目(2000061120) |
| |
| 摘 要： | 在考虑误差与载荷对蜗杆传动接触区域影响的基础上，提出了蜗杆齿面沿齿高方向的修形策略以控制其接触区域。同时，通过预设定的误差曲线对蜗杆齿面沿螺旋线方向修形以降低因误差和载荷变形所引入的传动比误差。弹性接触分析和传动比分析结果表明，蜗杆齿面沿两个方向同时修形能够实现蜗杆传动的啮合控制。
|
| 关 键 词： | 蜗杆传动 齿面修形 传动误差 啮合控制 载荷 |
| 文章编号： | 1004-132X(2003)23-1999-03 |
Conjugate Control of Worm Gearing Influenced by the Errors and the Load |
| |
| Shi Wankai,Qin Datong,Xu Wujiao Chongqing University,Chongqing,China.Conjugate Control of Worm Gearing Influenced by the Errors and the Load[J].China Mechanical Engineering,2003,14(23):1999-2001. |
| |
| Authors: | Shi Wankai Qin Datong Xu Wujiao Chongqing University Chongqing China |
| |
| Abstract: | After considering influences of the errorsand the load on contact zone, the profile modification ofworm along the height direction has been proposed tocontrol the contact zone of the worm gearing. At thesame time, the profile modification along the spilal direc-tion, by means of the pre--designed errors during grind-ing process of the worm,was adopted to reduce the trans-mission errors caused by the errors and load--dependentdeformation. The results from the elastic contact analysisand error analysis show that simultaneous modification ofthe worm along two directions can meet the requiremensof conjugate control. |
| |
| Keywords: | worm gearing profile modification transmission error conjugate control |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
