首页 | 本学科首页   官方微博 | 高级检索  
     

硼泥-改性淀粉絮凝剂处理印染废水的实验研究
引用本文:聂新卫,马希晨,徐同宽,宋辉,宋晶晶.硼泥-改性淀粉絮凝剂处理印染废水的实验研究[J].大连轻工业学院学报,2005,24(1):39-41.
作者姓名:聂新卫  马希晨  徐同宽  宋辉  宋晶晶
作者单位:大连轻工业学院,化工与材料学院,辽宁,大连,116034
摘    要:采用预处理的硼泥和改性淀粉絮凝剂对印染废水进行处理,通过正交实验确定了硼泥、改性淀粉絮凝剂的用量、pH及搅拌时间等因素对絮凝效果的影响。当硼泥絮凝剂用量为250mg/L,改性淀粉絮凝剂用量为3mg/L,废水pH为11.7,搅拌时间(单指加完硼泥后的搅拌时间,下同)120s时,废水处理效果较理想,COD的去除率为82.4%,色度去除率为76.7%,浊度去除率为98.1%,处理后水pH为9.5。以金舟纺织集团的印染废水为研究对象,效果较理想。

关 键 词:印染废水  硼泥  淀粉  絮凝剂
文章编号:1005-4014(2005)01-0039-03

Experimental investigation on dying wastewater treatment with boron sludge and modified starch flocculant
NIE Xin-wei,MA Xi-chen,XU Tong-kuan,SONG Hui,SONG Jing-jing.Experimental investigation on dying wastewater treatment with boron sludge and modified starch flocculant[J].Journal of Dalian Institute of Light Industry,2005,24(1):39-41.
Authors:NIE Xin-wei  MA Xi-chen  XU Tong-kuan  SONG Hui  SONG Jing-jing
Abstract:The paper reports the investigation on treatment of dying wastewater with pre-processed boron sludge and modified starch flocculant. The optimal parameters for flocculation were determined by orthogonal experiment as follows: pH, 11.7; boron sludge dosage, 250 mg/L; modified starch flocculant dosage, 3 mg/L; stirring time (the time after boron sludge added into dying wastewater, thereafter sameness ), 120 second. The experiment was performed in the Golden-Boat Textile Group. The treatment results are listed as: COD removal rate is 82.4%, colority removal rate is 76.7%, turbidity removal rate is (98.1%), and pH of water after treatment is 9.5.
Keywords:dying wastewater treatment  boron sludge  starch  flocculant
本文献已被 CNKI 维普 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号