| Abstract: | Various types of bonding agents have been tried with blends of bagasse fibers and some thermoplastics such as low‐density polyethylene (LDPE), high‐density polyethylene (HDPE), polystyrene (PS), polypropylene (PP), and polyvinyl chloride (PVC). These bonding agents are, namely, pentaerythritol tetracrylate (PETA), 1,6 hexandiol diacrylate (HDA), and dicumyl peroxide (DCP). In addition, a traditional coupling agents 3‐aminopropyltrimethoxy silane (AMPS) and di‐aminopropyltrimetoxy silane (DAMPS) were included for comparison. Electron beam (EB) irradiation is applied only for LDPE and HDPE at 40 and 10 kGy, respectively, before mixing with bagasse fibers. The data obtained reveal that incorporation of bonding agents remarkably increases the mechanical properties for all samples under investigation; the maximum improvement is observed in LDPE followed by HDPE, PP, PS, and PVC composites. Also, the physical properties enhanced but not at the same degree as mechanical properties. Among the tested bonding agents, it was found that PETA, DCP followed by DAMPS have highest efficiency in LDPE, whereas in case of HDPE, EB radiation was higher than PETA followed by DCP. PETA was superior in case of PS composites. Furthermore, PETA and HDA experienced higher efficiency than DAMPS and AMPS in case of PP and PVC composites. Comparison between the properties of thermoplastic composites and medium density fiberboard (MDF) reveals that most of the properties of thermoplastics composites are better than MDF. However, modulus of rupture of MDF was found to be slightly higher than thermoplastics except for PVC composite. POLYM. COMPOS., 2008. © 2008 Society of Plastics Engineers |
