| Abstract: | Increasing the rate of fruit and vegetable cooling is of economic significance for the following reasons: biochemical and microbiological processes are quickly suppressed; surface mass-exchange with ambient air is slowed down; power consumption is reduced, and the freezing output of cooling equipment and installations is increased.It was assumed that the fruits and vegetables in crates were arranged regularly and covered with thin paper of a negligible small thermal resistance in order to eliminate the infiltration of cold air within the layers. Crates were arranged on a pallet so that they touched horizontally. Thus, the packages form plates above and below the cooling air flow. Heat-exchange with a one-dimensional temperature field is established.It was found that intensification of cooling can be achieved by increasing the speed of cooling air as well as by stopping the process at a higher final temperature. Increasing the speed up to 5 m s−1 shortens the time of the process by a factor of two compared with the low speeds (0.3–0.5 m s−1) which are normally used. The product can be cooled until the temperature in the layer centre reaches 5°C, and the surface temperature about 2°C, which is low enough. Afterwards the cooled product is transferred to a freezing chamber or to a van-freezer. This factor results in a further halving of the cooling time. The combined effect of the two factors shortens the duration of the process by about 75% and increases the output of the cooling equipment from 3.5 to 4 times. |
