| 电瓶盖注射模设计 |
| |
| 引用本文： | 翁铸. 电瓶盖注射模设计[J]. 模具工业, 2003, 0(1): 34-36 |
| |
| 作者姓名： | 翁铸 |
| |
| 作者单位： | 广西工学院,广西柳州,545006 |
| |
| 摘 要： | 介绍了民用手提式电瓶瓶盖的成型工艺及注射模结构 ,为解决塑件上、下部内侧孔的抽芯和复位 ,模具采用了斜滑块结构 ,可自动抽芯、复位 ,提高了生产效率
|
| 关 键 词： | 电瓶盖 注射模 斜滑块 抽芯 |
| 文章编号： | 1001-2168(2003)01-0034-03 |
| 修稿时间： | 2002-07-23 |
Design of the Injection Mould for the Battery-Cell Lid |
| |
| WENG Zhu. Design of the Injection Mould for the Battery-Cell Lid[J]. Die & Mould Industry, 2003, 0(1): 34-36 |
| |
| Authors: | WENG Zhu |
| |
| Abstract: | The technological process for forming the lid of the portable battery cell and the structure of the injection mould were introduced. The structure with a slanted slide was used to the mould for solving the problems of core pulling and mould reposition for the inner side holes at the top and bottom of the plastic part. Automatic core pulling and mould reposition were realized and increased the production efficiency. |
| |
| Keywords: | battery_cell lid injection mould slanted slide core pulling |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
