Influence of the metal electrode on the characteristics of thermal Ta2O5 capacitors

The effect of various electrodes (Al, W, TiN) deposited by evaporation (Al) and sputtering (W, TiN) on the electrical characteristics of thermal thin film (15-35 nm) Ta₂O₅ capacitors has been investigated. The absolute level of leakage currents, breakdown fields, mechanism of conductivity, dielectric constant values are discussed in the terms of possible reactions between Ta₂O₅ and electrode material as well as electrode deposition process-induced defects acting as electrically active centers. The dielectric constant values are in the range 12-26 in dependence on both Ta₂O₅ thickness and gate material. The results show that during deposition of TiN and Al a reaction that worsens the properties of Ta₂O₅ occurs while there is not an indication for detectable reduction of Ta₂O₅ when top electrode is W, and the leakage current is 5-7 orders of magnitude lower as compared to Al and TiN-electroded capacitors. The high level of leakage current for TiN and Al gate capacitors are related to the radiation defects generated in Ta₂O₅ during sputtering of TiN, and damaged interface at the electrode due to a reaction between Al and Ta₂O₅, respectively. It is demonstrated that the quality of the top electrode affects the electrical characteristics of the capacitors and the sputtered W is found to be the best. The sputtered W gate provides Ta₂O₅ capacitors with a good quality: the current density <7 × 10⁻¹⁰ A/cm² at 1 V (0.7 MV/cm, 15 nm thick Ta₂O₅). W deposition is not accompanied by an introduction of a detectable damage leading to a change of the properties of the initial as-grown Ta₂O₅ as in the case of TiN electrode. Damage introduced during TiN sputtering is responsible for current deterioration (high leakage current) and poor breakdown characteristics. It is concluded that the sputtered W top electrode is a good candidate as a top electrode of storage capacitors in dynamic random access memories giving a stable contact with Ta₂O₅, but sputtering technique is less suitable (favorable) for deposition of TiN as a metal electrode due to the introduction of radiation defects causing both deterioration of leakage current and poor breakdown characteristics.