|
|||||
|
|
| 基于ANSYS软件的钻机回转器齿轮齿根应力计算方法 | |
| 引用本文： | 高勇,冯达辉,王敬国,王普. 基于ANSYS软件的钻机回转器齿轮齿根应力计算方法[J]. 矿山机械, 2011, 0(10) |
| 作者姓名： | 高勇 冯达辉 王敬国 王普 |
| 作者单位： | 中煤科工集团西安研究院; |
| 摘 要： | 笔者应用Unigraphics NX4.0软件对钻机回转器齿轮进行三维建模,并将三维模型导入ANSYS软件,避免了直接利用ANSYS建立齿轮模型的复杂过程。总结了UG软件和ANSYS软件的接口技术,降低了导入过程中模型的数据丢失与失真度;应用ANSYS软件对齿轮模型的齿根应力进行了计算与分析,并应用传统的齿轮齿根应力简化公式,对ANSYS软件计算结果进验算,验算结果表明,ANSYS软件计算结果准确,满足设计要求;同时,为了计算和比较的方便,利用C语言编写了齿轮齿根应力简化公式程序。 |
| 关 键 词： | 齿根应力 ANSYS计算 齿根应力简化计算公式 |
Method of calculating stress of gear dedendum of gyrator in drill rig based on ANSYS |
|
| GAO Yong,FENG Dahui,WANG Jingguo,WANG Pu Xi'an Research Institute,China Coal Technology , Engineering Group Corp,Xi'an ,Shaanxi,China. Method of calculating stress of gear dedendum of gyrator in drill rig based on ANSYS[J]. Mining & Processing Equipment, 2011, 0(10) | |
| Authors: | GAO Yong FENG Dahui WANG Jingguo WANG Pu Xi'an Research Institute China Coal Technology & Engineering Group Corp Xi'an Shaanxi China |
| Affiliation: | GAO Yong,FENG Dahui,WANG Jingguo,WANG Pu Xi'an Research Institute,China Coal Technology & Engineering Group Corp,Xi'an 710077,Shaanxi,China |
| Abstract: | Unigraphics NX4.0 is used to conduct 3D modeling for the gear of the gyrator in the drill rig, and then the completed 3D model is imported into ANSYS. This avoids the complex process of gear modeling directly by ANSYS. The interface technology of UG and ANSYS is concluded, which reduces data loss and distortion of the model during model being imported. In addition, ANSYS is applied to calculate and analyze the dedendum stress of the gear model, and traditional simplified formulas of calculating the dedendum... |
| Keywords: | dedendum stress calculation by ANSYS simplified formula of calculating dedendum stress |
| 本文献已被 CNKI 等数据库收录！ | |