| 塑料注射模并行设计与动态模拟模型的研究 |
| |
| 引用本文： | 郭幼丹.塑料注射模并行设计与动态模拟模型的研究[J].机械设计与制造,2006(12):164-166. |
| |
| 作者姓名： | 郭幼丹 |
| |
| 作者单位： | 集美大学,厦门,361021 |
| |
| 摘 要： | 传统的塑料模具产品开发模式大多采用串行过程,设计质量往往受设计者自身条件的限制。通过塑料注射模并行设计与动态模拟模型的研究,为高质量的塑料注射模具设计提供依据。
|
| 关 键 词： | 塑料模具 并行设计 动态模拟 模型 |
| 文章编号： | 1001-3997(2006)12-0162-02 |
| 收稿时间： | 2006-04-23 |
| 修稿时间： | 2006年4月23日 |
Research on simultaneous design and dynamical simulating model of plastic injecting mold |
| |
| GUO You-dan.Research on simultaneous design and dynamical simulating model of plastic injecting mold[J].Machinery Design & Manufacture,2006(12):164-166. |
| |
| Authors: | GUO You-dan |
| |
| Affiliation: | Jimei University, Xiamen 361021 ,China |
| |
| Abstract: | Traditional developing mode of plastic mold is a serial course and the quality of design is often limited by the designers' conditions. Simultaneous design and dynamical simulating model of plastic injecting mold have been studied in this paper and support to design good plastic injecting mold. |
| |
| Keywords: | Plastic mold Concurrent engineering Dynamic simulate Former |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
