High-pressure sorption isotherms and sorption kinetics of CH4 and CO2 on coals

Using a manometric experimental setup, high-pressure sorption measurements with CH₄ and CO₂ were performed on three Chinese coal samples of different rank (VR_r = 0.53%, 1.20%, and 3.86%). The experiments were conducted at 35, 45, and 55 °C with pressures up to 25 MPa on the 0.354-1 mm particle fraction in the dry state. The objective of this study was to explore the accuracy and reproducibility of the manometric method in the pressure and temperature range relevant for potential coalbed methane (CBM) and CO₂-enhanced CBM (CO₂-ECBM) activities (P > 8 MPa, T > 35 °C). Maximum experimental errors were estimated using the Gauss error propagation theorem, and reproducibility tests of the high-pressure sorption measurements for CH₄ and CO₂ were performed. Further, the experimental data presented here was used to explicitly study the CO₂ sorption behaviour of Chinese coal samples in the elevated pressure range (up to 25 MPa) and the effects of temperature on supercritical CO₂ sorption isotherms.The experiments provided characteristic excess sorption isotherms which, in the case of CO₂ exhibit a maximum around the critical pressure and then decline and level out towards a constant value. The results of these manometric tests are consistent with those of previous gravimetric sorption studies and corroborate a crossover of the 35, 45, and 55 °C CO₂ excess sorption isotherms in the high-pressure range. The measurement range could be extended, however, to significantly higher pressures. The excess sorption isotherms tend to converge, indicating that the temperature dependence of CO₂ excess sorption on coals at high-pressures (>20 MPa) becomes marginal. Further, all CO₂ high-pressure isotherms measured in this study were approximated by a three-parameter excess sorption function with special consideration of the density ratio of the “free” phase and the sorbed phase. This function provided a good representation of the experimental data.The maximum excess sorption capacity of the three coal samples for methane ranged from 0.8 to 1.6 mmol/g (dry, ash-free) and increased from medium volatile bituminous to subbituminous to anthracite. The medium volatile bituminous coal also exhibited the lowest overall excess sorption capacity for CO₂. However, the subbituminous coal was found to have the highest CO₂ sorption capacity of the three samples. The mass fraction of adsorbed substance as a function of time recorded during the first pressure step was used to analyze the kinetics of CH₄ and CO₂ sorption on the coal samples. CO₂ sorption proceeds more rapidly than CH₄ sorption on the anthracite and the medium volatile bituminous coal. For the subbituminous coal, methane sorption is initially faster, but during the final stage of the measurement CO₂ sorption approaches the equilibrium value more rapidly than methane.