| 负载型非晶态催化剂催化工业双戊烯加氢研究 |
| |
| 引用本文： | 蒋丽红,苗雨欣,王昊,王亚明.负载型非晶态催化剂催化工业双戊烯加氢研究[J].昆明理工大学学报(理工版),2012(5):69-73,78. |
| |
| 作者姓名： | 蒋丽红 苗雨欣 王昊 王亚明 |
| |
| 作者单位： | 昆明理工大学 化学工程学院,云南 昆明650500 |
| |
| 基金项目： | 云南省重点学科建设项目 |
| |
| 摘 要： | 采用XRD、SEM、BET对自制催化剂进行表征,对该催化剂催化工业双戊烯加氢反应工艺进行了研究,得到适宜工艺条件为：反应温度170℃,反应压力5 MPa,反应时间60 min,50 mL原料双戊烯对应的催化剂用量1.5 g,该条件下重现性良好,双戊烯转化率达99.2%以上,对孟烷收率达95.3%以上.
|
| 关 键 词： | 工业双戊烯 负载型非晶态催化剂 催化加氢 对孟烷 |
Study on Industrial Dipentene Hydrogenation Catalyzed by Supported Amorphous Catalyst |
| |
| JIANG Li-hong,MIAO Yu-xin,WANG Hao,WANG Ya-ming.Study on Industrial Dipentene Hydrogenation Catalyzed by Supported Amorphous Catalyst[J].Journal of Kunming University of Science and Technology(Natural Science Edition),2012(5):69-73,78. |
| |
| Authors: | JIANG Li-hong MIAO Yu-xin WANG Hao WANG Ya-ming |
| |
| Affiliation: | (Faculty of Chemical Engineering,Kunming University Science and Technology,Kunming 650500,China) |
| |
| Abstract: | XRD,SEM and BET are used to characterize self-made catalyst.The process of industrial dipentene hydrogenation catalyzed by the catalyst is then studied.The suitable conditions are obtained： reaction temperature 170 ℃,reaction pressure 5 MPa,reaction time 60 min,50 mL dipentene corresponding catalyst dosage 1.5 g.The reproducibility of the conditions is good,with a dipentene conversion rate of 99.2%,and p-menthane yield 95.3% or more. |
| |
| Keywords: | dipentene supported amorphous catalyst catalytic hydrogenation p-menthane |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
