| MATLAB下的线性系统稳态误差分析和校正 |
| |
| 引用本文： | 童佳,吴根忠. MATLAB下的线性系统稳态误差分析和校正[J]. 机电工程, 2005, 22(8): 30-33 |
| |
| 作者姓名： | 童佳 吴根忠 |
| |
| 作者单位： | 嘉兴学院机电与建筑工程学院,浙江,嘉兴,314000;浙江工业大学,信息学院,浙江,杭州,310032 |
| |
| 摘 要： | 就干扰引起的线性自动控制系统的稳态误差进行了深入的分析，用MATLAB编程实现了稳态误差的计算，对系统进行了合适的校正，使系统能按预定的设计要求正常工作。还介绍了在SIMULINK环境下构造线性自动控制系统的仿真模型的方法。
|
| 关 键 词： | 干扰信号 稳态误差 校正 |
| 文章编号： | 1001-4551(2005)08-0030-04 |
| 收稿时间： | 2005-01-07 |
| 修稿时间： | 2005-04-11 |
The Stable Tolerance Analysis and Correction of Linear Automatic Control System Based on MATLAB |
| |
| TONG Jia,Wu Gen-zhong. The Stable Tolerance Analysis and Correction of Linear Automatic Control System Based on MATLAB[J]. Mechanical & Electrical Engineering Magazine, 2005, 22(8): 30-33 |
| |
| Authors: | TONG Jia Wu Gen-zhong |
| |
| Abstract: | This paper deeply explores the stable tolerance of linear automatic control system led by the interference signal. Programming with MATLAB computes the stable tolerance and the system is properly adjusted. The system works normally according to the desired requirement. The paper also introduces the simulating model configuring a system under the SIMULINK environment. |
| |
| Keywords: | interference signal stable tolerance correction |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
