| 注射成形制备TiNi多孔材料 |
| |
| 引用本文： | 肖丰强. 注射成形制备TiNi多孔材料[J]. 山东冶金, 2014, 0(3): 29-31 |
| |
| 作者姓名： | 肖丰强 |
| |
| 作者单位： | 济钢集团有限公司技术中心,山东济南250101 |
| |
| 摘 要： | 利用粉末注射成形工艺制备了TiNi多孔材料,研究了注射喂料的流变性能,造孔剂NaCl对多孔材料性能的影响。试验结果表明:喂料的流变性能良好;造孔剂可以显著提高材料的孔隙度、孔径;能谱分析和X射线物相分析没有发现NaCl残留,TiNi多孔材料主要由Ni3Ti、Ti2Ni、TiNi、TiC相组成。
|
| 关 键 词： | TiNi多孔材料 粉末注射成形 造孔剂 孔隙度 |
Preparing of TiNi Porous Material by Powder Injection Forming |
| |
| XIAO Fengqiang. Preparing of TiNi Porous Material by Powder Injection Forming[J]. Shandong Metallurgy, 2014, 0(3): 29-31 |
| |
| Authors: | XIAO Fengqiang |
| |
| Affiliation: | XIAO Fengqiang (The Technology Center of Jinan Iron and Steel Group Corporation, Jinan 250101, China) |
| |
| Abstract: | The TiNi porous material was prepared by powder injection forming. The rheological behavior of the feedstock and the influence of pore-forming agen NaCl on the quality of the porous material specimens were investigated. The results showed that the rheological behavior of the feedstock was fine,the pore forming material significantly improved the porosity and pore size of the TiNi porous material,the NaCl residue was not detected by energy spectrum analysis and X-ray diffraction analysis,the TiNi porous material mainly contains Ni3Ti,Ti2Ni,TiNi and TiC phases. |
| |
| Keywords: | TiNi porous material powder injection forming pore-forming agent porosity |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
