| 汽车模具的电刷镀和喷焊快速修复 |
| |
| 引用本文： | 赵玮霖,罗静,杨惠,孙智富,杨明波.汽车模具的电刷镀和喷焊快速修复[J].模具工业,2007,33(2):64-66. |
| |
| 作者姓名： | 赵玮霖 罗静 杨惠 孙智富 杨明波 |
| |
| 作者单位： | 1. 重庆工学院,重庆,400050
2. 武汉理工大学,湖北,武汉,430070 |
| |
| 摘 要： | 介绍了几种典型模具快速修复工艺方法,并对汽车地板革成形模和汽车半轴摆动辗压模的修复进行了研究。研究结果表明:对于汽车地板革成形模,采用刷镀工艺可获得和基体结合良好,满足使用要求的修复镀层;对于汽车半轴摆动辗压模,采用喷焊修复工艺可以得到硬度60-65 HRC,满足使用要求的模具表面修复喷焊层。
|
| 关 键 词： | 地板革成形模 半轴摆动辗压模 模具修复 刷镀 喷焊 |
| 文章编号： | 1001-2168（2007）02-0064-03 |
| 收稿时间： | 2006-09-14 |
| 修稿时间： | 2006年9月14日 |
Rapid recondition by electro chemical machining and spray welding for automotive die and mould |
| |
| ZHAO Wei-lin,LUO Jing,YANG Hui,SUN Zhi-fu,YANG Ming-bo.Rapid recondition by electro chemical machining and spray welding for automotive die and mould[J].Die & Mould Industry,2007,33(2):64-66. |
| |
| Authors: | ZHAO Wei-lin LUO Jing YANG Hui SUN Zhi-fu YANG Ming-bo |
| |
| Abstract: | Some typical technique for rapid mould recondition was stated. An investigation was carded out for the recondition of a mould for the forming of automotive plastic floor board and a half-axle swing forging die. The result shows that the application of eleclro chemical machining can obtain the cladding which bonds well with matrix and meets the requirement for the mould for the forming of floor board; and the use of spray welding techn/que can achieve 60-65HRC degree of hardness of surface coverage for the automotive half-axle swing forging die. |
| |
| Keywords: | mould for forming of plastic floor board half-axle swing forging die mould recondition electro chemical machining spray welding |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
