首页 | 本学科首页   官方微博 | 高级检索  
     

纳米晶体钛基掺钽TiO2薄膜的摩擦磨损性能
引用本文:于春杭,邵红红,许晓静,翟瑞. 纳米晶体钛基掺钽TiO2薄膜的摩擦磨损性能[J]. 材料研究学报, 2011, 0(4): 433-438
作者姓名:于春杭  邵红红  许晓静  翟瑞
作者单位:江苏大学材料科学与工程学院
基金项目:国家自然科学基金重点项目51074079资助~~
摘    要:采用室温直流反应磁控溅射技术在纳米晶体钛表面制备掺钽TiO2薄膜,研究了掺Ta量对纳米晶体钛基TiO2薄膜摩擦磨损性能的影响。结果表明:在室温模拟人体体液条件下,掺钽TiO2薄膜与不锈钢淬火钢球(Φ4mm)对摩的磨损率为10^-6-10^-5mm^3·m^-1 N^-1级;随着Ta含量的增加,薄膜的摩擦系数和磨损率呈先...

关 键 词:材料表面与界面  掺钽TiO_2薄膜  磁控溅射  纳米晶体钛  摩擦磨损

Friction/Wear Properties of Ta-Doped TiO2 Films on Surface of Nano-Grained Ti
YU Chunhang SHAO Honghong XU Xiaojing ZHAI Rui. Friction/Wear Properties of Ta-Doped TiO2 Films on Surface of Nano-Grained Ti[J]. Chinese Journal of Materials Research, 2011, 0(4): 433-438
Authors:YU Chunhang SHAO Honghong XU Xiaojing ZHAI Rui
Affiliation:YU Chunhang(**) SHAO Honghong XU Xiaojing ZHAI Rui (School of Materials Science and Engineering,Jiangsu University,Zhenjiang 212013)
Abstract:The friction/wear properties of TiO2 films with different Ta-doped content deposited on surface of nano-grained Ti by DC reactive magnetron sputtering technology at room temperature were investigated.The results show that the Ta-doped TiO2 films exhibit the specific wear rate on the order of 10-6-10-5mm3·m-1·N-1 sliding against a stainless steel quenched ball(2 mm in radius) at room temperature by simulation body fluid.With the increasing Ta content in TiO2 films,the friction coefficient and wear rate of TiO2 films were gradually decreased and then increased.And the TiO2 film with about 22%Ta-doped has the smallest friction coefficient(0.20) and wear rate(1.5×10-6mm3·m-1·N-1).The good wear-resistance of the TiO2 films with about 22%Ta-doped is in accordance with its high hardness-to -modulus ratio,good corrosion-resistance and low friction coefficient.
Keywords:surface and interface in the materials  Ta-doped TiO2 films  magnetron sputtering  nano-grained Ti  friction and wear
本文献已被 CNKI 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号