三维片上网络正四面体裂变拓扑结构研究

旨在研究新型三维片上网络正四面体裂变拓扑结构，给出了该拓扑结构的生成过程；对该拓扑结构进行了编码设计和路由设计。通过对gpNoCsim片上网络仿真器进行三维扩展，对正四面体裂变拓扑结构进行性能仿真实验。仿真结果表明，在均匀负载模式下，正四面体裂变拓扑结构的平均延时和平均跳数均低于Mesh结构，当注入率为0.02时，平均延时比Mesh结构低16.8%、平均跳数比Mesh结构少5.5%；在局部负载模式下，当注入率大于0.008时，正四面体裂变拓扑结构的平均延时和平均跳数与Mesh结构相比，均有明显改善；当注入率为0.014时，平均延时比 Mesh结构降低18.7%、平均跳数比 Mesh结构减少9.6%。说明正四面体裂变拓扑结构可用于三维片上网络拓扑结构设计。

Research on tetrahedron fission topology in three dimensional network-on-chip

This paper aims to research the tetrahedron fission topology that is a new type of three dimensional Network-on-Chip topology, gives generation process of topology and the design of encoding and routing. Through a three dimensional extension of the gpNoCsim which is a simulator on chip network, the simulation experiment of the tetrahedron fission topology is conducted. The simulation results show, tetrahedron fission topology can achieve lower average latency and fewer average hops than Mesh under uniform traffic pattern, When the injection rate is 0.02, comparing with Mesh, the average latency degrades by 16.8 % and the average hops decrease 5.5% ; Under localized traffic pattern, the average delay of tetrahedral fission topology and the average hops are significantly improved when the injection rate is greater than 0.008, Comparing with Mesh , tetrahedron fission leads to 18.7% decrease of the average latency and 9.6% decrease of the average hops when the injection rate is 0.014. It is shown that the tetrahedron fission topology can be used in the design of three dimensional Network-on-Chip topology.