Forming of aluminium alloy at temperatures just below melting point

In order to improve the mechanical properties of products, a forming process of a solid material at a temperature just below the melting point is proposed. The material is deformed at the semi-solid temperature due to the heat generation caused by plastic deformation. The tensile strength, elongation, hardness and toughness of the aluminium alloy (Al–7%Si–0.3%Mg) billet extruded at temperatures between 500 and 550 °C are compared with those of the billet extruded in the hot forming (450 °C) and the semi-solid (560 °C) temperatures. The billet temperature during forming is evaluated by the finite element simulation. The tensile strength and hardness of the billet extruded at 550 °C just below the solidus temperature are higher than those for a billet at 450 °C, and they are almost the same as those for a billet deformed at 560 °C in the semi-solid region. The elongation and toughness of the extruded billet at 550 °C are lower than those for a billet at 450 °C. The forming load at 550 °C is almost half of that at 450 °C. Cracking on the surface of the extruded billet occurs at a high punch speed. The calculated temperature when the solid billet is extruded in the semi-solid state agrees well with the experimental one at which the tensile and hardness are improved.