Investigating the microstructure and composition of cold gas-dynamic spray (CGDS) Ti powder deposited on Al 6063 substrate

The compositional variation, morphology and microstructure of cold gas-dynamic spray are of great importance for its proper application. This study investigates titanium powder deposition on an Al 6063 substrate using light optical microscopy, scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The composition was examined using energy dispersive X-ray spectroscopy (EDX), X-ray diffraction, X-ray photoelectron spectroscopy (XPS) and time-of-flight secondary ion mass spectrometry (ToF SIMS). Optical and electron microscopy revealed heavily deformed Ti powder particles penetrating 10 to 30 μm into the Al substrate. Examination using TEM did not reveal any evidence of second phases at the interface suggesting a sharp transition between the two metals. The presence of nanocrystals and grain refinement of both the coating and the substrate suggest the formation of a partial hetero-epitaxy condition near the interface. EDX results from a dedicated high-resolution scanning transmission electron microscope showed a sharp compositional change with a maximum inter-diffusion region of about 5 nm. Bonding of the coating to the substrate is therefore thought to be achieved by the particle/substrate interlocking and direct metal to metal bonding. However, it is most likely that the refine crystalline structure near the interface will be beneficial to the adhesion of the coating. XPS and ToF SIMS provided evidence of nitrogen pick-up during the spray process in the form of N and TiN even when utilizing Helium as the gas carrier. The presence of TiN suggests reaction of the Ti with the entrained air during spraying which explains the occurrence of flashing jet outside the nozzle. Investigation of the material properties using nanoindentation showed reasonably consistent hardness and elastic modulus values throughout the titanium coating and at the transition region. The hardness was slightly higher than typical commercially available bulk Ti.