Preparation and properties of porous polytetrafluoroethylene hollow fiber membrane through mechanical operations |
| |
| Authors: | Guochang Liu Congjie Gao Xiaoming Li Chungang Guo Ying Chen Jinglie Lv |
| |
| Affiliation: | 1. College of Chemistry and Chemical Engineering, Ocean University of China, Qingdao, China;2. Lab of Membrane Science and Technology, The Institute of Seawater Desalination and Multipurpose Utilization, State Oceanic Administration, Tianjin, China |
| |
| Abstract: | Porous polytetrafluoroethylene (PTFE) hollow fiber membranes were prepared from fine powder through a series of mechanical operations including paste extrusion, heat treatment, stretching and sintering. In contrast to conventional process, the heat treatment used in this study was performed at 200°C to 330°C (near the melting point) on the PTFE nascent hollow fiber (precursor of membrane). The results showed that the introduction of heat treatment step effectively improved the mechanical properties of precursors, the ultimate stress and strain increased observably with heat treatment temperature, which was beneficial to subsequently stretching precursors to make them porous. Furthermore, the morphological changes and improvement of membrane properties caused by stretching operation were investigated for porous PTFE hollow fiber membrane having finer pore size and higher porosity. The porous microstructure of nodes interconnected by fibrils varied depending on the stretching conditions, such as the stretching temperature, rate, and ratio. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 42696. |
| |
| Keywords: | extrusion manufacturing membranes morphology properties and characterization |
|
|
