| 基于Moldflow流动分析的薄壁注塑件成型工艺设计 |
| |
| 引用本文： | 钟皓东,徐灵杰,邓益民.基于Moldflow流动分析的薄壁注塑件成型工艺设计[J].塑料工业,2005,33(11):32-34. |
| |
| 作者姓名： | 钟皓东 徐灵杰 邓益民 |
| |
| 作者单位： | 浙江省宁波大学工学院,浙江,宁波,315211 |
| |
| 基金项目： | 2004年度浙江省自然科学基金人才培养专项支持（项目编号：R104247） |
| |
| 摘 要： | 提出了一个基于Moldflow的薄壁注塑件成型工艺设计的方法.将注塑成型质量分解为8项质量指标,并从Moldflow分析结果中提取相关数据,再利用加权法综合这些质量指标.通过选择具有代表性的近百组工艺参数,编写程序对其相应的成型质量进行比较,最终获得较为理想的成型工艺设计数据.
|
| 关 键 词： | Moldflow 注塑成型 优化设计 |
| 文章编号： | 1005-5770(2005)11-0032-03 |
| 收稿时间： | 2005-07-25 |
| 修稿时间： | 2005年7月25日 |
Injection Moulding Process Design of Thin-walled Plastics Products Based on Moldflow Flow Analysis |
| |
| ZHONG Hao-dong,XU Ling-jie,DENG Yi-min.Injection Moulding Process Design of Thin-walled Plastics Products Based on Moldflow Flow Analysis[J].China Plastics Industry,2005,33(11):32-34. |
| |
| Authors: | ZHONG Hao-dong XU Ling-jie DENG Yi-min |
| |
| Affiliation: | Faculty of Engineering, Ningbo University, Ningbo 315211, China |
| |
| Abstract: | A Moldflow flow analysis based method for injection moulding process design of thin-walled plastics parts was put forward. The moulding quality of the moulding was broken down into eight constituent criteria in this method, relevant data were retrieved from Moldflow analysis results, and these quality criteria were synthesized by means of weighting method. By analysing about one hundred sets of typical processing parameters, and comparing their synthesized moulding quality results implemented in a computer program, the relatively optimal moulding process parameters were reported in this paper. |
| |
| Keywords: | Moldflow Injection Moulding Process Optimal Design |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
