首页 | 本学科首页   官方微博 | 高级检索  
     

铁炭微电解-Fenton试剂联合氧化深度处理印染废水的研究
引用本文:姜兴华,刘勇健,金亮基.铁炭微电解-Fenton试剂联合氧化深度处理印染废水的研究[J].应用化工,2008,37(9).
作者姓名:姜兴华  刘勇健  金亮基
作者单位:1. 苏州科技学院,环境科学与工程学院,江苏,苏州,215011
2. 苏州科技学院,化学与生物工程学院,江苏,苏州,215011
摘    要:采用铁炭微电解-Fenton联合氧化技术对印染废水生化处理的出水进行深度处理,考察了pH值、H2O2投加量、铁炭体积比、反应时间对处理效果的影响。结果表明,最佳反应条件为:pH2~3,H2O2用量3.2 mL/L,铁炭体积比为1∶1,反应时间为90 min,COD的去除率达到90%以上,色度去除率为99%,盐度去除率为64%,各项指标均达到了印染废水的回用要求。

关 键 词:铁炭微电解  Fenton试剂  印染废水  深度处理

Study on advanced treatment of printing and dyeing wastewater by joint oxidation technology of iron-carbon micro-electrolysis and Fenton reagents
JIANG Xing-hua,LIU Yong-jian,JIN Liang-ji.Study on advanced treatment of printing and dyeing wastewater by joint oxidation technology of iron-carbon micro-electrolysis and Fenton reagents[J].Applied chemical industry,2008,37(9).
Authors:JIANG Xing-hua  LIU Yong-jian  JIN Liang-ji
Abstract:Advanced treatment of printing and dyeing wastewater by joint oxidation technology of iron-carbon micro-electrolysis and Fenton reagents was studied.The influence of pH,H2O2 adding amount,the volume ratio of iron to carbon on treating effect was studied.It is found that the best experimental conditions are as follows: pH is 2~3,H2O2 dosage is 3.2 mL/L,volume ratio of iron to carbon is 1 ∶1,reaction time 90 min.Under this condition,the removal of COD,chroma and salinity can reach 90%,99% and 64%,respectively.Each index met the reuse requirements of printing and dyeing water.
Keywords:iron-carbon micro-electrolysis  Fenton reagents  printing and dyeing wastewater  advanced treatment
本文献已被 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号