| Abstract: | In the context of a European union‐supported network on “Reactive Surfactants for Heterophase Polymerization,” different polymerizable surfactants (surfmers) have been synthesized and engaged in the emulsion polymerization of styrene, butyl acrylate, and acrylic acid. The thermomechanical properties of films cast from these different latices are reported in this article. The evolution of the mechanical properties with temperature and the effect of water molecules on these properties are studied. We observed that the studied surfactants do not influence the properties of the dry films. However, some differences due to grafting of reactive surfactants appeared when the films were wet. The amount of water uptake is drastically decreased when only reactive surfactants are present in the film. Concerning the mechanical behavior of the wet films, a decrease of the plastic flow stress is observed for all the samples whatever the nature of the surfactant (reactive or conventional). Hence, calorimetric measurements and dynamic mechanical analysis are used to identify the possible mechanisms that induce the change in the mechanical behavior of the latex films. In the case of reactive surfactant grafted to the polymer, the very low value of water uptake is accompanied by a plasticization of the polymer. In contrast, no plasticizing effect is observed in the case of nonreactive surfactant, even if the amount of water is very large. Finally, the tensile behavior of the styrene–butyl acrylate copolymer versus temperature is analyzed in the frame of the quasi point defects (qpd) model. Both rubber elasticity and chain orientation effects are taken into account to describe the behavior laws at large extensions (i.e., ? ≈ 1.2). © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1686–1700, 2002; DOI 10.1002/app.10548 |
