| 钟表齿轮滚刀齿廓的计算 |
| |
| 引用本文： | 国祥琴 裴金玲. 钟表齿轮滚刀齿廓的计算[J]. 西安工业学院学报, 1992, 12(2): 72-77 |
| |
| 作者姓名： | 国祥琴 裴金玲 |
| |
| 作者单位： | 西安工业学院机械系，西安工业学院机械系，西安工业学院计算机系，西安工业学院计算机系 |
| |
| 摘 要： | 描述了一种计算钟表齿轮滚刀齿廓的新方法——齿高等距计算法.按照此法计算,可使滚刀齿廓上的计算点均匀分布,提高滚刀的设计精度.这种方法可应用于类似的刀具设计中.
|
| 关 键 词： | 钟表 齿轮 齿廓 滚刀 |
THE CALCULATION ON TOOTH OUTLINE OF CLOCK-GEAR HOB |
| |
| Guo Xiangqin Bai Wanmin Pei Jinling Li Shihong. THE CALCULATION ON TOOTH OUTLINE OF CLOCK-GEAR HOB[J]. Journal of Xi'an Institute of Technology, 1992, 12(2): 72-77 |
| |
| Authors: | Guo Xiangqin Bai Wanmin Pei Jinling Li Shihong |
| |
| Affiliation: | Guo Xiangqin Bai Wanmin Pei Jinling Li Shihong |
| |
| Abstract: | A new calculation method of equaled-distance in height of tooth for outiine of the clock-gear hob is introduced. With this method, the calculated points distribution of the tooth outline are uniform, thus the design accuracy is increased remarkably. |
| |
| Keywords: | clock gear conjugate outline fine-module gear hob calculation of equaled angles |
| 本文献已被 CNKI 维普 等数据库收录！ |
