Characterization of gelation time and texture of gelatin and gelatin–polysaccharide mixed gels |
| |
Authors: | Linus G Fonkwe Ganesan Narsimhan Alice S Cha |
| |
Affiliation: | a Department of Agricultural and Biological Engineering, Biochemical and Food Process Engineering, Purdue University, West Lafayette, IN 47907-1146, USA;b Kraft Foods, Glenview, IL 60025, USA |
| |
Abstract: | The effects of cooling rate, holding temperature, pH and polysaccharide concentration on gelation characteristics of gelatin and gelatin–polysaccharide mixtures were investigated using a mechanical rheometer which monitored the evolution of G′ and G″. At low holding temperatures of 0 and 4 °C, elastic gelatin gels were formed whereas a higher holding temperature of 10 °C produced less elastic gels. At slow cooling rates of 1 and 2 °C/min, gelling was observed during the cooling phase in which the temperature was decreased from room temperature to the holding temperature. On the other hand, at higher cooling rates of 4 and 8 °C/min, no gelation was observed during the cooling phase. Good gelling behavior similar to that of commercial Strawberry Jell-O® Gelatin Dessert was observed for mixtures of 1.5 and 15 g sucrose in 100 ml 0.01 M citrate buffer containing 0.0029–0.0066 g low-acyl gellan. Also, these mixed gels were stronger than Strawberry Jell-O® Gelatin Desserts as evidenced by higher G′ and gel strength values. At a very low gellan content of 0.0029 g, increasing pH from 4.2 to 4.4 led to a decrease in the temperature at the onset of gelation, G′ at the end of cooling, holding and melting as well as an increase in gel strength. The gelation time was found to decrease to about 40 min for gelatin/sucrose dispersions in the presence of 0.0029 g gellan at pH 4.2 whereas the corresponding time at pH 4.4 was higher (79 min). In general, the gelation time of gelatin/sucrose dispersions decreased by a factor of 2 to 3 in the presence of low-acyl gellan. The addition of low-acyl gellan resulted in an increase in the gelation rate constant from 157.4 to 291 Pa. There was an optimum low-acyl gellan content for minimum gelation time, this optimum being pH dependent. Addition of guar gum also led to a decrease in gelation time to 73 min with a corresponding increase in the gelation rate constant to 211 Pa/min though these values were not sensitive to guar gum content in the range of 0.008–0.05 g. The melting temperature of gelatin/sucrose/gellan as well as gelatin/sucrose/guar mixtures did not differ significantly from that of pure gelatin or Strawberry Jell-O® Gelatin Desserts. At pH 4.2, the melting rate constant was highest at a low-acyl gellan content of 0.0029 g whereas the rate constant was insensitive to low-acyl gellan content at pH 4.4. Addition of guar did not seem to affect the melting temperature or the melting rate constant. |
| |
Keywords: | Gelatin Low-acyl gellan Guar gum Protein gel Gelation Mechanical properties Mixed gels |
本文献已被 ScienceDirect 等数据库收录! |
|