Pressure-Induced Phase Transformation of Controlled-Porosity Pb(Zr0.95Ti0.05)O3 Ceramics |
| |
Authors: | Bruce A Tuttle Pin Yang John H Gieske James A Voigt Timothy W Scofield David H Zeuch Walter R Olson |
| |
Affiliation: | Sandia National Laboratories, Albuquerque, New Mexico 87185 |
| |
Abstract: | Chemically prepared Pb(Zr0.95Ti0.05)O3 (PZT 95/5) ceramics were fabricated with a range of different porosity levels, while grain size was held constant, by systematic additions of added organic pore former (Avicel). Use of Avicel in amounts ranging from 0 to 4.0 wt% resulted in fired ceramic densities that ranged from 97.3% to 82.3%. Hydrostatic-pressure-induced ferroelectric (FE) to antiferroelectric (AFE) phase transformations were substantially more diffuse and occurred at lower hydrostatic pressures with increasing porosity. An ∼12 MPa decrease in hydrostatic transformation pressure per volume percent added porosity was observed. The decrease in transformation pressure with decreasing density was quantitatively consistent with the calculated macroscopic stress required to achieve a specific volumetric macrostrain (0.40%). This strain was equivalent to experimentally measured macrostrain for FE-to-AFE transformation. The macroscopic stress levels were calculated using measured bulk modulus values that decreased from 84 to 46 GPa as density decreased from 97.3% to 82.3%. Good agreement between calculated and measured values of FE-to-AFE transformation stress was obtained for ceramics fired at 1275° and 1345°C. |
| |
Keywords: | phase transformations pores/porosity lead zirconate titanate |
|