| 基于ANSYS重型商用车驱动桥壳有限元分析 |
| |
| 引用本文： | 姜武华,李强.基于ANSYS重型商用车驱动桥壳有限元分析[J].机械,2007,34(11):38-40. |
| |
| 作者姓名： | 姜武华 李强 |
| |
| 作者单位： | 合肥工业大学,机械与汽车工程学院,安徽,合肥,230009 |
| |
| 摘 要： | 驱动桥是汽车中的重要部件,应具有足够的强度和刚度,针对某重型商用车后驱动桥出现局部开裂现象,首先在UG中建立了该桥壳几何模型,然后在Hyper Mesh软件中进行网格划分,最后将其导入到ANSYS有限元分析软件中加载和约束,对该商用车后驱动桥壳进行了有限元分析计算,并提出改进方案.
|
| 关 键 词： | 驱动桥壳 UG ANSYS 有限元分析 ANSYS 重型 商用车 驱动桥壳 有限元分析 based vehicle commercial housing driving 方案 改进 分析计算 约束 加载 分析软件 网格划分 Hyper Mesh 几何模型 |
| 文章编号： | 1006-0316（2007）11-0038-03 |
| 修稿时间： | 2007-09-17 |
The finite element analysis for driving axle housing of heavy commercial vehicle based on ANSYS |
| |
| JIANG Wu-hua,LI Qiang.The finite element analysis for driving axle housing of heavy commercial vehicle based on ANSYS[J].Machinery,2007,34(11):38-40. |
| |
| Authors: | JIANG Wu-hua LI Qiang |
| |
| Affiliation: | School of Mechanical and Automobile Engineering, HefeiUniversityofTechnology, Hefei230009, China |
| |
| Abstract: | The driving axle, as an impartment part of automobile, should be have enough intensity and flexibility. In view of breach phenomenon in rear drive axle housing of heavy commercial vehicle, Firstly, geometry model of the axle housing was built by UG software, plotted in girding form by Hyper Mesh software and analyzed and computed by ANSYS software. Secondly, an better project was advanced. |
| |
| Keywords: | drive axle housing UG ANSYS the finite element analysis |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
