Microstructure characterization of Sn-Ag solder joints between stud bumps and metal pads

The microstructure of the flip-chip solder joints fabricated using stud bumps and Pb-free solder was characterized. The Au or Cu stud bumps formed on Al pads on Si die were aligned to corresponding metal pads in the substrate, which was printed with Sn-3.5Ag paste. Joints were fabricated by reflowing the solder paste. In the solder joints fabricated using Au stud bumps, Au-Sn intermetallics spread over the whole joints, and the solder remained randomly island-shaped. The δ-AuSn, ε-AuSn₂, and η-AuSn₄ intermetallic compounds formed sequentially from the Au stud bump. The microstructure of the solder joints did not change significantly even after multiple reflows. The AuSn₄ was the main phase after reflow because of the fast dissolution of Au. In the solder joints fabricated using Cu stud bumps, the scallop-type Cu₆Sn₅ intermetallic was formed only at the Cu interface, and the solder was the main phase. The difference in the microstructure of the solder joints with Au and Cu stud bumps resulted from the dissolution-rate difference of Au and Cu into the solder.