首页 | 本学科首页   官方微博 | 高级检索  
     

降低石钢烧结矿低温还原粉化率的研究
引用本文:张玉柱,客海滨,王丽丽,邢宏伟.降低石钢烧结矿低温还原粉化率的研究[J].烧结球团,2007,32(2):27-32.
作者姓名:张玉柱  客海滨  王丽丽  邢宏伟
作者单位:1. 河北理工大学
2. 063000,河北省唐山市,河北理工大学研究生学院04冶金
摘    要:根据石钢烧结矿冷态性能较好,但低温还原粉化性较差的情况,进行了降低烧结矿低温还原粉化率的实验室试验。结果发现,烧结矿中次生Fe2O3含量高、微裂纹多是导致其低温还原粉化性恶化的主要原因,要降低还原粉化率,应着重改善其微观结构。在石钢烧结原料条件下,烧结矿中MgO控制在2.3%时,烧结矿微观结构改善。

关 键 词:MgO含量  矿物组成  微观结构
修稿时间:2007-01-09

Investigation on Improving RDI of SHIGANG Sinter
Zhang Yuzhu et al..Investigation on Improving RDI of SHIGANG Sinter[J].Sintering and Pelletizing,2007,32(2):27-32.
Authors:Zhang Yuzhu
Affiliation:Zhang Yuzhu et al.
Abstract:Point at the problem that the cold state property of SHIGANG sinter is better but the low temperature reduction break-down property is bad, the laboratory experiment to improve sinter RDI have been done. The result shows that more secondary Fe2O3 and inside crack in sinter caused the low temperature reduction degradation index worse. In order to improve the RDI,the sinter microstructure must be regarded, under the condition of SHIGANG sintering raw material, the MgO content in sinter must be controlled around 2.3%.
Keywords:RDI
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号