| 风力发电机电机转子焊接工艺 |
| |
| 引用本文： | 马振,牟立婷,庄明辉,吕迎,连军,李慕勤.风力发电机电机转子焊接工艺[J].电焊机,2017(12):117-121. |
| |
| 作者姓名： | 马振 牟立婷 庄明辉 吕迎 连军 李慕勤 |
| |
| 作者单位： | 1. 佳木斯大学材料科学与工程学院,黑龙江佳木斯,154007;2. 佳木斯大学药学院,黑龙江佳木斯,154007;3. 佳木斯电机股份有限公司,黑龙江佳木斯,154007 |
| |
| 摘 要： | 针对轴材25CrMo和辐板Q345D,采用焊条电弧焊-气体保护焊复合焊方法,J507R打底层,ER50-6填充盖面、预热温度250℃、层间温度300℃、550℃/3h焊后热处理缓冷等工艺制备完整的焊接接头。通过拉伸试验、弯曲试验、冲击试验、维氏硬度试验以及观察分析焊接接头显微组织和冲击断口形貌进行研究,结果表明,采用该焊接工艺获得的焊接接头具有良好的焊接质量,为25CrMo和Q345D焊接的材料选择、工艺制订提供参考。
|
| 关 键 词： | 25CrMo钢 冲击韧性 金相组织 焊接工艺评定 |
Welding technology of motor rotor for wind driven generator |
| |
| Abstract: | A welding method combining manual arc welding and gas shielded welding is used for 25CrMo and Q345D stainless steels,and the welded joints are prepared with the technologies,including J507R for backing welding,ER50-6 for filling and cosmetic welding,preheat temperature of 250 ℃,interpass temperature of 300 ℃,postweld heat treatment of 550 ℃/3 h,slow cooling and so on.The microstructure and properties in weld metal zone of 25CrMo and Q345D steels are studied by tensile test,bending test,impact test,Vickers hardness test,observation and analysis of the microstructure of welded joints and the appearance of impact fractures.The results show that the welded joints obtained by this welding technology have good welding quality,which provides a reference for materials selection and welding technology for the welding of 25CrMo and Q345D steels. |
| |
| Keywords: | 25CrMo steel impact toughness metallographic structure welding procedure qualification |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
