| 衣架机头三维数值模拟 |
| |
| 引用本文： | 周宏志,江波. 衣架机头三维数值模拟[J]. 橡塑技术与装备, 2005, 31(2): 1-5 |
| |
| 作者姓名： | 周宏志 江波 |
| |
| 作者单位： | 北京化工大学机电工程学院,北京,100029 |
| |
| 基金项目： | 高等学校博士学科点专项科研基金项目(200100010002)资助 |
| |
| 摘 要： | 利用美国FLUENT公司研究开发的Polyflow软件，以衣架型机头为基本的几何模型。对其流道内的聚合物熔体流动进行了数值模拟分析，建立控制方程，找出相关边界条件，以1组机头基本尺寸数据为例，计算得到了整个衣架机头流道内部的压力、速度分布图，最后通过分析幂律流体压力和速度分布图，对出口处料流的均匀性进行了讨论。
|
| 关 键 词： | 挤出 衣架机头 界面 数值模拟 polyflow |
| 文章编号： | 1009-797(2005)02-0001-05 |
| 修稿时间： | 2004-10-19 |
Three-dimensional value simulation of a clothes rack type head |
| |
| Zhou Hongzhi,Jiang Bo. Three-dimensional value simulation of a clothes rack type head[J]. China Rubber/Plastics Technology & Equipment, 2005, 31(2): 1-5 |
| |
| Authors: | Zhou Hongzhi Jiang Bo |
| |
| Abstract: | Make use of the Polyflow software developed by American FLUENT company, taking theclothes rack type head as a based geometric mold, analyzed the value simulation of poly melt flow insidethe sprue, set up the control equation, found out the relative boundary condition, taking a group of thebase dimensions of head for instance, we achieved the pressure distributing and the velocity distributingchart inside sprue of the whole clothes rack type head through the calculation. Finally analyzed thepower law flow pressure and velocity distributing, and discussed the uniformity of feed flow at the wayout. |
| |
| Keywords: | extrusion clothes rack type head interface value simulation polyflow |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
