DMA analysis of the damping of ethylene–vinyl acetate/acrylonitrile butadiene rubber blends

The mechanical and damping properties of blends of ethylene–vinyl acetate rubber (VA content > 40% wt) (EVM)/acrylonitrile butadiene rubber (NBR), with 1.4 phr BIPB bis (tert‐butyl peroxy isopropyl) benzene] as curing agent, were investigated by DMA and DSC. The effect of chlorinated polyvinyl chloride (CPVC), silica, carbon black, and phenolic resin (PF) as a substitute curing agent, on the damping and mechanical properties of EVM/NBR blends were studied. The results showed that 10 phr CPVC did not contribute to the damping of EVM700/NBR blends; Silica could dramatically improve the damping of EVM700/NBR blends because of the formation of bound rubber between EVM700/NBR and silica, which appeared as a shoulder tan δ peak between 20 and 70°C proved by DMA and DSC. This shoulder tan δ peak increased as the increase of the content of EVM in EVM/NBR blends. The tensile strength, modulus at 100% and tear strength of the blend with SiO₂ increased while the elongation at break and hardness decreased comparing with the blend with CB. PF, partly replacing BIPB as the curing agent, could significantly improve the damping of EVM700/NBR to have an effective damping temperature range of over 100°C and reasonable mechanical properties. Among EVM600, EVM700, and EVM800/NBR/silica blend system, EVM800/NBR/silica blend had the best damping properties. The EVM700/NBR = 80/10 blend had a better damping property than EVM700/NBR = 70/20. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2012