| 两相区淬火+回火对600 MPa级低合金高强钢组织与性能的影响 |
| |
| 引用本文： | 杨鹏,张朋彦,纪久张. 两相区淬火+回火对600 MPa级低合金高强钢组织与性能的影响[J]. 金属热处理, 2021, 46(6): 59-64. DOI: 10.13251/j.issn.0254-6051.2021.06.012 |
| |
| 作者姓名： | 杨鹏 张朋彦 纪久张 |
| |
| 作者单位： | 安徽工业大学 冶金工程学院, 安徽 马鞍山 243002 |
| |
| 摘 要： | 对某600 MPa级低合金高强钢采用了淬火+回火的热处理方式,研究了不同回火温度以及不同淬火温度对其组织性能的影响.结果表明,随着回火温度的升高,屈服强度、抗拉强度以及屈强比都呈下降趋势,伸长率逐渐上升,在620℃以上回火时出现第二类回火脆性,导致冲击性能急剧降低;在淬火温度达到820℃后得到的两相区淬火组织为铁素体+...
|
| 关 键 词： | 低合金高强钢 两相区淬火 组织 力学性能 |
| 收稿时间： | 2021-01-03 |
Effect of intercritical quenching and tempering on microstructure and mechancial properties of 600 MPa HSLA steel |
| |
| Yang Peng,Zhang Pengyan,Ji Jiuzhang. Effect of intercritical quenching and tempering on microstructure and mechancial properties of 600 MPa HSLA steel[J]. Heat Treatment of Metals, 2021, 46(6): 59-64. DOI: 10.13251/j.issn.0254-6051.2021.06.012 |
| |
| Authors: | Yang Peng Zhang Pengyan Ji Jiuzhang |
| |
| Affiliation: | School of Metallurgical Engineering, Anhui University of Technology, Ma'anshan Anhui 243002, China |
| |
| Abstract: | A 600 MPa high strength low alloy (HSLA) steel was heat treated by quenching and tempering, and influence of different tempering temperature and different quenching temperature on its microstructure and mechanical properties were investigated. The results show that the tensile strength, yield strength and yield ratio of the steel decrease with the increase of tempering temperature, but the elongation increases gradually. Type II temper brittleness appears when the tempering temperature is above 620 ℃, which result in sharp decrease of the impact performance. When the quenching temperature reaches 820 ℃, ferrite+granular bainite microstructure is obtained, which is conducive to preventing the crack propagation and ensure high impact performance. |
| |
| Keywords: | high strength low alloy (HSLA) steel intercritical quenching microstructure mechanical properties |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《金属热处理》浏览原始摘要信息 |
|
点击此处可从《金属热处理》下载免费的PDF全文 |
|
