| 井下胶轮车后机架结构改进设计 |
| |
| 引用本文： | 赵留强,王铁,樊运平,柴少彪. 井下胶轮车后机架结构改进设计[J]. 煤炭科学技术, 2009, 0(10) |
| |
| 作者姓名： | 赵留强 王铁 樊运平 柴少彪 |
| |
| 作者单位： | 太原理工大学车辆工程系;煤炭科学研究总院太原研究院; |
| |
| 摘 要： | 针对某种井下胶轮车后机架早期断裂问题,提出后机架结构改进方案。利用ANSYS建立改进前后机架三维几何和有限元模型。基于此模型进行有限元静力、模态分析,确定后机架结构的静态和动态响应特性。根据有限元分析结果,对比机架实际破坏部位,验证有限元分析的可靠性和改进方案的合理性。
|
| 关 键 词： | 井下胶轮车 后机架 ANSYS 三维建模 有限元分析 |
Improved Design on Rear Mechanical Frame Structure of Mine Rubber Tyre Vehicle in Underground Mine |
| |
| ZHAO Liu-qiang,WANG Tie,FAN Yun-ping,CHAI Shao-biao. Improved Design on Rear Mechanical Frame Structure of Mine Rubber Tyre Vehicle in Underground Mine[J]. Coal Science and Technology, 2009, 0(10) |
| |
| Authors: | ZHAO Liu-qiang WANG Tie FAN Yun-ping CHAI Shao-biao |
| |
| Affiliation: | 1.Department of Vehicle Engineering;Taiyuan University of Technology;Taiyuan 030024;China;2.Taiyuan Research Institute;China Coal Research Institute;Taiyuan 030006;China |
| |
| Abstract: | According to the early fracture problems of the rear frame for the mine rubber tyre vehicle in an underground mine,an improved plan of the rear frame was provided.An ANSYS was applied to establish the 3D geometric and finite element model to improve the front and rear frames.Based on the finite element static and modal analysis with the model,the static and dynamic response features of the rear frame structure were set up.According to the results of the finite element analysis,the actual failure location of... |
| |
| Keywords: | underground mine rubber tyre vehicle rear mechanical frame ANSYS three-dimensional modeling finite element analysis |
| 本文献已被 CNKI 等数据库收录！ |
