Research of micro EDM/ECM method in same electrolyte with running wire tool electrode |
| |
| Affiliation: | 1. Department of Precision Engineering, The University of Tokyo, 7-3-1 Hongo, Bunkyo-ku, Tokyo 113-8656, Japan;2. Hamada Heavy Industries Ltd., Hukuoka 804-0053, Japan;1. Aeronautical Engineering Institute, Civil Aviation University of China, No.2898 Jinbei Rd, Dongli District, Tianjin, 300300, China;2. Department of Precision Engineering, the University of Tokyo, Hongo 7-3-1, Bunkyo, Tokyo, 113-8656, Japan;3. School of Materials Science and Engineering, Tianjin University, No.135 Yaguan Rd, Haihe Education Park, Tianjin, 300350, China;1. The University of Tokyo, 7-3-1, Hongo, Bunkyo-ku Tokyo 113-8656, JAPAN;2. Harbin Institute of Technology, Harbin, 150001, CHINA;1. School of Automation, Nanjing University of Science & Technology, Nanjing, China;2. Department of Mechanical Engineering, KU Leuven & Member Flanders Make, Celestijnenlaan 300 – box 2420, 3001 Heverlee, Belgium |
| |
| Abstract: | A micro rod machining method which can switch between electrical discharge machining (EDM) and electrochemical machining (ECM) by attaching/detaching a diode to/from a bipolar pulse generator in parallel to the working gap was newly developed using a wire electrode made of tungsten. The problem of the wire electrode wear was eliminated by the use of the wire electrochemical turning (WECT) method in which the tungsten wire electrode is continuously running. The ultra-short bipolar pulse current was generated by the electrostatic induction feeding method where a pulse voltage is coupled to the working gap through a feeding capacitance. The machining characteristics of three types of wire guide; disk-shaped WC guide, laminated wire guide and cylindrical acrylic guide, were studied. The experimental results showed that the cylindrical acrylic guide has the best machining characteristics without the influence of guide wear and with less stray current flowing through the working gap. Using the cylindrical acrylic guide, the influences of the feeding capacitance C1, and the total amplitude of the pulse voltage on the machining characteristics were studied. Finally, a stainless steel SUS 304 micro-rod with a high aspect ratio of 14 was fabricated efficiently by using the EDM and ECM modes for rough and finish machining in sequence with the same setup, pulse generator, and neutral electrolyte. |
| |
| Keywords: | Electrochemical machining Electrical discharge machining Wire electrochemical turning Tungsten Micromachining Electrostatic induction feeding method Micro-rods |
| 本文献已被 ScienceDirect 等数据库收录！ |
|
