| 周转箱塑件热流道注射模具设计 |
| |
| 引用本文： | 黄虹,王选伦,夏华.周转箱塑件热流道注射模具设计[J].中国塑料,2005,19(11):98-102. |
| |
| 作者姓名： | 黄虹 王选伦 夏华 |
| |
| 作者单位： | 重庆工学院材料学院,重庆400050 |
| |
| 基金项目： | 重庆市自然科学基金项目（CSTC,2005BB3074） |
| |
| 摘 要： | 与普通流道注射成型工艺和模具相比，周转箱塑件热流道注射成型模具的分型面由4个减少为2个分型面，模具结构简化。详细讨论了热流道系统的结构与尺寸设计计算、热流道板加热功率的计算、热流道板线膨胀量的计算及线膨胀的克服措施。
|
| 关 键 词： | 注射模具 热流道 结构设计 |
| 文章编号： | 1001-9278（2005）11-0098-05 |
| 收稿时间： | 2005-09-06 |
| 修稿时间： | 2005-09-06 |
Design of Injection Mold with Hot Runners for Plastics Turnover Boxes |
| |
| HUANG Hong, WANG Xuan-lun, XIA Hua.Design of Injection Mold with Hot Runners for Plastics Turnover Boxes[J].China Plastics,2005,19(11):98-102. |
| |
| Authors: | HUANG Hong WANG Xuan-lun XIA Hua |
| |
| Affiliation: | College of Materials, Chongqing Institute of Technology, Chongqing 400050, China |
| |
| Abstract: | Comparison of hot runner injection mould with common ones for plastics turnover boxes as well as their processing technology showed that the hot runner injection mould had two parting lines, whereas the common one had four, therefore the former is simpler. The calculation of the size, heating power, linear swell value of hot runner system was also discussed in detail. |
| |
| Keywords: | injection mould hot runner structure design |
| 本文献已被 CNKI 维普 等数据库收录！ |
