首页 | 本学科首页   官方微博 | 高级检索  
     

攀枝花尾矿制备透水混凝土的实验研究
引用本文:毛雨琴,沈新颖,朱路平,崔晏.攀枝花尾矿制备透水混凝土的实验研究[J].上海第二工业大学学报,2018(1):48-52.
作者姓名:毛雨琴  沈新颖  朱路平  崔晏
作者单位:上海第二工业大学环境与材料工程学院;攀枝花学院材料工程学院
基金项目:上海电子废弃物资源化协同创新中心开放课题(B50ZS120003B-10), 上海第二工业大学研究生基金(A01GY16F030) 上海市联盟计划项目(LM201462), 上海自然科学基金资助项目(14ZR1417100)资助
摘    要:以攀枝花尾矿为原料制备透水混凝土,采用填充体积法进行配合比设计,通过投料法和插捣法进行透水混凝土的搅拌成型,考察了水灰比(W/C)、设计孔隙率等对试块性能的影响。结果表明,当设计孔隙率P为15%,水灰比为0.30时试块抗压强度达到最大值29.2 MPa,并且透水系数2 mm/s,能达到一般轻型抗压透水施工要求。

关 键 词:攀枝花尾矿    透水混凝土    配合比设计    透水系数

Experimental Study on Preparation of Pervious Concrete from Panzhihua Tailings
MAO Yu-qin,SHEN Xin-ying,ZHU Lu-ping and CUI Yan.Experimental Study on Preparation of Pervious Concrete from Panzhihua Tailings[J].Journal of Shanghai Second Polytechnic University,2018(1):48-52.
Authors:MAO Yu-qin  SHEN Xin-ying  ZHU Lu-ping and CUI Yan
Affiliation:School of Environmental and Materials Engineering, Shanghai Polytechnic University,School of Materials Engineering, Panzhihua University,School of Environmental and Materials Engineering, Shanghai Polytechnic University and School of Materials Engineering, Panzhihua University
Abstract:The pervious concrete was prepared by using Panzhihua tailings as raw material. The mix ratio design was carried out by filling volume method. The mixing and forming of pervious concrete was carried out by feeding method and tamping method. The effect of water/cement ratio (W=C) and design porosity on the performance of the experimental block were investigated. The results show that when the design porosity P is 15%, W/C is 0.30, the compressive strength of the test block reaches its maximum of 29.2 MPa, and the water permeability coefficient is above 2 mm/s, which can meet the general requirements of lightweight compressive pervious construction.
Keywords:Panzhihua tailings  pervious concrete  mix ratio design  permeability coefficient
本文献已被 CNKI 等数据库收录!
点击此处可从《上海第二工业大学学报》浏览原始摘要信息
点击此处可从《上海第二工业大学学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号