Behavior of Dental/Implant Alloys in Commercial Mouthwash Solution Studied by Electrochemical Techniques |
| |
Authors: | Daniel?Mareci Sorin?Iacob?Strugaru Sorin?Iacoban Email author" target="_blank">Georgiana?BolatEmail author Corneliu?Munteanu |
| |
Affiliation: | 1.Faculty of Chemical Engineering and Environmental Protection,“Gheorghe Asachi” Technical University of Iasi,Iasi,Romania;2.Faculty of Mechanical Engineering,“Gheorghe Asachi” Technical University of Iasi,Iasi,Romania |
| |
Abstract: | This study investigates the electrochemical behavior of the various dental materials: Paliag (Ag-Pd based), Wiron 99 (Ni-Cr based), Cp-Ti (commercial pure titanium), and experimental Ti12Mo5Ta alloy in commercial mouthwash solution with 500 ppm F? (Oral B®) and compares it with the behavior of the same dental materials in artificial saliva. Linear potentiodynamic polarization (LPP) and electrochemical impedance spectroscopy (EIS) are the electrochemical procedures of investigation. The passivation of all dental samples in artificial saliva and mouthwash solution occurred spontaneously at open circuit potential. The corrosion current density of all tested dental materials in mouthwash solution were low (1-2 μA/cm2). The results suggest a non-predominant fluoride effect on the passive layer formed on all samples at open circuit potential. No passivation could be established with Paliag alloy when polarized in mouthwash solution. The EIS results confirm that all dental sample exhibit passivity in mouthwash solution at open circuit potential (polarization resistance was around 5 × 105 Ω cm2). For Paliag alloy after LPP in mouthwash solution the protectiveness passive layer was no more present. The corrosion resistances of four dental materials in mouthwash solution are in the following order: Ti12Mo5Ta > Cp-Ti > Wiron 99 > Paliag. |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|