| 圆柱斜齿轮精锻成形数值模拟与试验研究 |
| |
| 引用本文： | 李晓冬,薛克敏,周结魁,李萍,石文超. 圆柱斜齿轮精锻成形数值模拟与试验研究[J]. 塑性工程学报, 2011, 18(2). DOI: 10.3969/j.issn.1007-2012.2011.02.005 |
| |
| 作者姓名： | 李晓冬 薛克敏 周结魁 李萍 石文超 |
| |
| 作者单位： | 合肥工业大学,材料科学与工程学院,合肥230009 |
| |
| 基金项目： | 国家大学生创新性实验计划资助项目，安徽省二OO八科技攻关资助项目 |
| |
| 摘 要： | 为探索圆柱斜齿轮精锻成形的新工艺,针对某一参数的圆柱斜齿轮,采用浮动凹模的工艺方案,对其进行数值模拟与物理试验。分析不同压下量下,斜齿轮的成形效果和脱模过程中的速度场、等效应变场,并与传统的闭式挤压成形进行对比。结果表明,圆柱斜齿轮采用浮动凹模的成形工艺较采用传统工艺,载荷下降约30%,脱模时,锻件齿形在模腔内沿螺旋方向做刚性平移运动,齿形几乎不产生塑性变形。为进一步研究圆柱斜齿轮精锻成形工艺提供了参考。
|
| 关 键 词： | 圆柱斜齿轮 数值模拟 脱模 浮动凹模 |
Simulation and experimental research on the precision forging of helical gear |
| |
| LI Xiao-dong,XUE Ke-min,ZHOU Jie-kui,LI Ping,SHI Wen-chao. Simulation and experimental research on the precision forging of helical gear[J]. Journal of Plasticity Engineering, 2011, 18(2). DOI: 10.3969/j.issn.1007-2012.2011.02.005 |
| |
| Authors: | LI Xiao-dong XUE Ke-min ZHOU Jie-kui LI Ping SHI Wen-chao |
| |
| Affiliation: | LI Xiao-dong XUE Ke-min ZHOU Jie-kui LI Ping SHI Wen-chao(School of Materials Science & Engineering,Hefei University of Technology,Hefei 230009 China) |
| |
| Abstract: | A forming method of floating die for the specific helical gears was studied by both numerical simulation and physical experiments.The forming effect of different reduction,the velocity and equivalent strain field during demoulding were analyzed.The floating die scheme was compared with the conventional scheme.The results show that the forming load of floating die can be reduced by about 30% compared with the conventional scheme.During demoulding,the teeth of the helical gear make rigid translation along the... |
| |
| Keywords: | helical gear numerical simulation demoulding floating die |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
