Interdependence of piezoelectric coefficient and film thickness in LiTaO3 cantilevers |
| |
Authors: | Anjneya Verma Namanu Panayanthatta Arun Ichangi Thomas Fischer Laurent Montes Edwige Bano Sanjay Mathur |
| |
Affiliation: | 1. Institute of Inorganic Chemistry, University of Cologne, Cologne, Germany;2. Grenoble INP, IMEP-LaHC, Grenoble, France |
| |
Abstract: | Electromechanical energy demands on homogenous thick films of piezoceramics with sufficiently large piezoelectric constant and reproducible performance. Single-phase LiTaO3 films deposited by sol-gel processing have been fabricated as cantilevers to investigate the interdependence of dielectric and piezoelectric properties as a function of film thickness. Phase pure LiTaO3 films with varying thickness in the range of 2.07-4.37 µm on stainless steel substrates were obtained after calcination of samples at 650°C. The relative permittivity of optimized spin-coated films peaked at 479.73 (1 kHz), whereas the piezoelectric coefficient (d33 mode) determined by piezoresponse force microscopy was in the range of 21-24 pm/V. The effect of poling was studied through the butterfly and phase curves. A figure of merit (FOM) up to 3.29 (10−18 m2/V2) was determined for cantilever devices, which were able to generate a peak-to-peak voltage of 0.046-0.15 V using a 1 MΩ resistor as an impedance load at a fixed acceleration of 1.5 m/s2. While the power density was in the range of ~4-20 × 10−9 W/m3, which increased with the increasing film thickness. The leakage current density decreased in the range of 4 × 10−5-6 × 10−7 A/m2 in the same direction. As both ferroelectric and piezoelectric properties of LiTaO3 films are dependent on film thickness, an optimal energy conversion efficiency was obtained for a thickness of ~3 µm. Furthermore, these devices were tested up to a temperature of 150°C for voltage generation. Given the need for lead-free piezoelectric materials for environmental applications, these LiTaO3 cantilevers are very promising for vibrational energy harvester (VEH) applications especially due to their cost effectiveness, small size, stability at higher temperatures, and repeatable properties, which makes them suitable for MEMS devices for industrial applications. |
| |
Keywords: | LiTaO3 perovskite piezoceramics thick films vibrational energy harvesters |
|
|