| 固溶处理对双相不锈钢S32003组织的影响 |
| |
| 引用本文： | 张寿禄.固溶处理对双相不锈钢S32003组织的影响[J].特殊钢,2019,40(6):65-67. |
| |
| 作者姓名： | 张寿禄 |
| |
| 作者单位： | 1太原钢铁（集团）有限公司先进不锈钢材料国家重点实验室，太原030003 ；
2山西太钢不锈钢股份有限公司技术中心，太原030003 |
| |
| 摘 要： | 通过金相、扫描电镜、透射电镜观察和X射线能谱仪分析,研究了900～1 250℃固溶处理对S32003双相不锈钢组织的影响。结果表明,900℃固溶处理时,钢中有氮化物析出,固溶温度≥950℃时,氮化物全部溶解;随着固溶温度升高,α相含量增加,γ相含量下降。最佳固溶处理温度在1040℃;随着固溶温度的提高,α相和γ相的晶粒尺寸在逐渐增大,1100℃以上晶粒明显长大。
|
| 收稿时间： | 2019-05-17 |
Effect of Solution Treatment on Microstructure of Duplex Stainless Steel S32003 |
| |
| Zhang Shoulu.Effect of Solution Treatment on Microstructure of Duplex Stainless Steel S32003[J].Special Steel,2019,40(6):65-67. |
| |
| Authors: | Zhang Shoulu |
| |
| Affiliation: | 1 State Key Laboratory of Advanced Stainless Steel Materials, Taiyuan Iron & Steel( Group) Co Ltd, Taiyuan 030003 ；
2 Technology Center, Shanxi Taigang Stainless Steel Co Ltd, Taiyuan 030003 |
| |
| Abstract: | Effect of solution-treated at 900 - 1250℃ on microstructure of steel duplex stainless S32003 has been studied by metallographic, scanning electron microscopy ( SEM) , transmission electron microscopy (TEM) observation and X-ray energy dispersive spectroscopy(EDS) analysis. The results show that the nitride precipitates in steel at 900℃ , in order to dissolve nitride of hot rolling steel, solution temperature must be up to 950 °C ； With the increase of solution temperature , phase content in steel increases α and γ phase content decreases. The optimum solution temperature is 1040℃； As the solution temperature increase, the grain size of α and γ phase is gradually growing up, the grain is obvious coarsening when the temperature is greater than 1100 °C. |
| |
| Keywords: | |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《特殊钢》浏览原始摘要信息 |
|
点击此处可从《特殊钢》下载全文 |
|
