A crystal-tolerant fully integrated CMOS low-IF dual-band GPS receiver

This paper presents the design of a dual-band L1/L2 GPS receiver, that can be easily integrated in portable devices (mainly GSM mobile phones). For the ease of integration with GSM wireless systems the receiver can tolerate most of the common GSM crystals, besides the GPS crystals, this will eliminate the need to use another crystal on board. A new frequency plan is presented to satisfy this requirement. A low-IF receiver architecture is used for dual-band operation with analog on-chip image rejection. The receiver is composed of a narrow-band LNA for each band, dual down-conversion mixers, a variable-gain channel filter, a 2-bit analog-to-digital converter, and a fully integrated frequency synthesizer including an on-chip VCO and loop filter. The complex filter can accept IF frequency variation of 10% around 4.092 MHz which allows the use of the commonly used 10/13/26 MHz GSM crystals and all the GPS crystals. The synthesizer generates the LO signals for both L1/L2 bands with an average phase noise of −95 dBc/Hz. The receiver exhibits maximum gain of 112 and 115 dB, noise figures of 4 and 3.6 dB, and input compression points of −76 and −79 dBm for L1 and L2, respectively. An on-chip variable-gain channel filter provides IF image rejection greater than 25 dB and gain control range over 80 dB. The receiver is designed in 0.13 μm CMOS technology and consumes 18 mW from a 1.2-V supply.