| 纤维增强PA66注塑熔接痕性能的工艺优化 |
| |
| 引用本文： | 杨扬,董斌斌,刘春太. 纤维增强PA66注塑熔接痕性能的工艺优化[J]. 工程塑料应用, 2004, 32(3): 32-34 |
| |
| 作者姓名： | 杨扬 董斌斌 刘春太 |
| |
| 作者单位： | 郑州大学橡塑模具国家工程研究中心,郑州,450002;郑州大学橡塑模具国家工程研究中心,郑州,450002;郑州大学橡塑模具国家工程研究中心,郑州,450002 |
| |
| 基金项目： | 河南省自然科学研究项目(2003430207)和河南省青年骨干教师资助项目 |
| |
| 摘 要： | 针对注塑过程中纤维增强PA66制品出现的熔接痕缺陷，利用Taguchi方法设计了L9实验矩阵，分析了注塑压力、熔体温度、注射速率和保压压力等工艺因素对注塑件熔接痕拉伸强度的影响，预测了最大拉伸强度和最佳工艺条件，与实验结果具有很好的一致性。
|
| 关 键 词： | 纤维增强尼龙66 注塑 熔接痕 成型工艺 |
| 修稿时间： | 2003-11-17 |
OPTIMIZATION OF PROCESS TECHNOLOGY TO STRENGTHEN WELD LINES IN FIBER-REINFORCED PA66 INJECTION MOLDING |
| |
| Yang Yang,Dong Binbin,Liu Chuntai. OPTIMIZATION OF PROCESS TECHNOLOGY TO STRENGTHEN WELD LINES IN FIBER-REINFORCED PA66 INJECTION MOLDING[J]. Engineering Plastics Application, 2004, 32(3): 32-34 |
| |
| Authors: | Yang Yang Dong Binbin Liu Chuntai |
| |
| Abstract: | A L9 experimental matrix design based on Taguchi method was conducted to reslove the defect of weld lines in fiber-reinforced PA66 injection molding. The effect of factors such as injection pressure, melt temperature, injection rate and packing pressure on the tensile strength of weld lines was analyzed. The optimum tensile strength and processing conditions were predicted and a good agreement with the experimental results was obtained. |
| |
| Keywords: | fiber-reinforced PA66 injection molding weld lines process technology |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
