| 适合挤出-滚圆法造粒的物料流变力学性能 |
| |
| 引用本文： | 包家汉,潘家祯. 适合挤出-滚圆法造粒的物料流变力学性能[J]. 安徽工业大学学报, 2004, 21(1): 19-22 |
| |
| 作者姓名： | 包家汉 潘家祯 |
| |
| 作者单位： | 安徽工业大学,机械工程学院,安徽,马鞍山,243002;华东理工大学,机械工程学院,上海,200237 |
| |
| 摘 要： | 采用四点弯曲法，测出挤出-滚圆法造粒时挤出物的弯曲强度和弹性模量，说明为制备质量较佳的球形颗粒，物料的水分比必须控制在一定范围内。实验采用的微晶纤维素．当水分比为10时，可制备出质量良好的球形颗粒，此时挤出物弯曲强度为0．32MPa，弹性模量E为7．5MPa。另一方面，挤出物在自重下的破断长度，亦可作为评价其强度的一种简便的手段.
|
| 关 键 词： | 挤出-滚圆:流变力学性能 弹性模量 |
| 文章编号： | 1671-7872(2004)01-0019-04 |
| 修稿时间： | 2003-04-11 |
Rhelogical and mechanical properties of materials suited for extrusion-spheronization |
| |
| BAO Jia-han,PAN Jia-zhen. Rhelogical and mechanical properties of materials suited for extrusion-spheronization[J]. Journal of Anhui University of Technology, 2004, 21(1): 19-22 |
| |
| Authors: | BAO Jia-han PAN Jia-zhen |
| |
| Affiliation: | BAO Jia-han1,PAN Jia-zhen2 |
| |
| Abstract: | The bending strength and Young's modulus of extruded materials are tested through four-point flexure testing. The moisture of materials must be controlled in a certain range to produce nicer spherical pellets that can be obtained if the moisture of water is about 1.0 for microcrystalline celluloses applied in the experiment. The bending strength of the extrusion is 0.32 MPa and Young's modulus is 7.5 MPa. The length of fragmentation by the weight of extrusion can be taken as a simple and convenient means to estimate its strength. |
| |
| Keywords: | extrusion-spheronization rhelogical and mechanical properties Young's modulus |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
