| 对称复合板冷轧变形模式的上限分析 |
| |
| 引用本文： | 李宝绵,许光明,崔建忠.对称复合板冷轧变形模式的上限分析[J].复合材料学报,2004,21(3):120-124. |
| |
| 作者姓名： | 李宝绵 许光明 崔建忠 |
| |
| 作者单位： | 东北大学 材料电磁过程研究教育部重点实验室, 沈阳 110004 |
| |
| 基金项目： | 国家高技术研究发展计划(863计划) |
| |
| 摘 要： | 应用上限法建立了对称复合板冷轧变形模式的数学模型,在此基础上对软复层复合板在不同条件下冷轧时的变形模式进行了计算,给出了相关计算曲线。计算结果表明,依过程参数的不同,软复层复合板冷轧时存在比例变形、界面撕开及不稳定变形三种可能的变形模式。加工率越大、界面结合强度越高、基体材料的相对强度和复合板轧后的相对厚度越小,则均匀变形区越大,界面撕开区越小。不稳定变形区仅在基体材料的相对厚度和相对强度足够大时才存在。
|
| 关 键 词： | 对称复合板 冷轧 上限法 变形模式 |
| 文章编号： | 1000-3851(2004)03-0120-05 |
| 收稿时间： | 2003-04-11 |
| 修稿时间： | 2003-06-16 |
AN UPPER BOUND ANALYSIS OF THE DEFORMATION MODE OF COLD SANDWICH ROLLING |
| |
| LI Baomian,XU Guangming,CUI Jianzhong.AN UPPER BOUND ANALYSIS OF THE DEFORMATION MODE OF COLD SANDWICH ROLLING[J].Acta Materiae Compositae Sinica,2004,21(3):120-124. |
| |
| Authors: | LI Baomian XU Guangming CUI Jianzhong |
| |
| Affiliation: | The Key Laboratory of Electromagnetic Processing of Material, Minister of Education, Northeastern University, Shenyang 110004, China |
| |
| Abstract: | A mathematical model of cold symmetrical sandwich rolling was established by applying the upper bound method.The deformation mode was calculated for the sandwich with soft cladding during cold rolling. The relative calculating results were presented graphically. It is shown that there exist three possible deformation modes, namely proportional deformation, interface splitting, and unsteady deformation, depending on the process parameters. Larger reduction, stronger interface bonding, smaller relative base-metal strength and rolled thickness increase the proportional deformation zone and decrease the interface splitting zone. The unsteady deformation zone exists only when the relative base-metal strength and thickness are large enough. |
| |
| Keywords: | symmetrical sandwich cold rolling upper bound method deformation mode |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
| 点击此处可从《复合材料学报》浏览原始摘要信息 |
|
点击此处可从《复合材料学报》下载全文 |
|
