Experimental studies of 4-inch pipe whip test under BWR loca conditions

Pipe whip tests or jet discharge tests have been performed at the Japan Atomic Energy Research Institute, which simulate the instantaneous circumferential guillotine break of primary coolant piping in nuclear power plants. The present paper describes the results of the pipe whip tests using test pipes of 4 inch diameter, under the BWR LOCA conditions, which were performed from 1979 to 1981. The tests were carried out at an initial pressure of about 6.8 MPa and an initial temperature of about 285°C.The test pipe was 114.3 mm (4 in) in diameter, 8.6 mm in thickness and 4500 mm in length. The four pipe whip restraints used in the tests were the U-bar type of 8 mm in diameter and fabricated from Type 304 stainless steel. The experimental parameters were the clearance (30, 50 and 100 mm) and the overhang length (250, 400, 550 and 1000 mm).The main purpose of these tests is to investigate the effects of the clearance and the overhang length on the pipe whip behavior. It has been clarified from the test results that a smaller clearance and a shorter overhang length causes the deformation of the pipe and restraints to be minimized, and the test pipe collapses near the setting point of the restraints with the overhang length of 1000 mm.