An investigation of the hole machining processes on woven carbon-fiber reinforced polymers (CFRPs) using abrasive waterjets

An investigation of the hole cutting and drilling processes on woven carbon-fiber reinforced polymer sheets using abrasive waterjet (AWJ) is presented. The drilling process uses a stationary AWJ to impinge a target material to make a hole, while the cutting process requires an AWJ to penetrate the workpiece before moving in a circular path to cut a hole. It is found that the holes machined by both the processes exhibit similar geometrical features, where the diameter at the top is greater than at the bottom. It is further found that the holes from the drilling process have a better roundness than those from cutting process primarily due to the jet instability during cutting movement. Plausible trends of the hole characteristics (e.g., diameter and wall inclination) and defects (e.g., delamination) with respect to the process parameters are discussed. It is shown that water pressure is the major parameter affecting hole defects. The hole drilling process yields more severe defects than the cutting process because of the initial impact of the jet. Predictive models for machined hole diameter in both processes are developed. The model predictions are in good agreement with the experimental data under the corresponding conditions.